Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   34.711013] [drm] Setting GART location based on new memory map
[   34.711026] [drm] Loading R100 Microcode
[   34.711085] [drm] writeback test succeeded in 2 usecs
[   34.976791] eth1: New link status: Connected (0001)
[   34.976865] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[   34.991607] eth1: New link status: Disconnected (0002)
[   35.816172] e100: eth0 NIC Link is Up 100 Mbps Full Duplex
[   35.816320] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   45.496042] eth1: no IPv6 routers present
[   45.992046] eth0: no IPv6 routers present
[   75.637352] eth1: New link status: Association Failed (0006)
[   80.020016] hermes @ e0ba0000: Timeout waiting for command 0x0002 completion.
comm: file 2 is not in sorted order
[   80.020016] eth1: Unable to disable port while reconfiguring card
[   80.020016] eth1: Resetting instead...
[   85.006543] eth1: Unexpected scan data length 66, atom_len 304, offset 4
[   97.244448] eth1: New link status: Association Failed (0006)
[   98.786826] eth1: New link status: Connected (0001)
[  101.672053] Clocksource tsc unstable (delta = -136088806 ns)
[  434.262510] mtrr: no MTRR for e8000000,1000000 found
[  440.706231] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[  440.706261] agpgart-intel 0000:00:00.0: putting AGP V2 device into 4x mode
[  440.706292] pci 0000:01:00.0: putting AGP V2 device into 4x mode
[  440.923809] [drm] Setting GART location based on new memory map
[  440.923822] [drm] Loading R100 Microcode
[  440.923879] [drm] writeback test succeeded in 1 usecs
[  470.803287] __ratelimit: 3 callbacks suppressed
[  470.803292] ACPI: EC: missing confirmations, switch off interrupt mode.
[  478.343938] eth1: New link status: Association Failed (0006)
[  480.176884] eth1: New link status: Association Failed (0006)
[  481.582118] eth1: New link status: Connected (0001)