This is armoken-laptop. Now 22:04:57 Mon Aug 4  2014

armoken-laptop login: r8169 0000:08:00.0 enp8s0: link down
r8169 0000:08:00.0 enp8s0: link down
IPv6: ADDRCONF(NETDEV_UP): enp8s0: link is not ready
iwlwifi 0000:09:00.0: L1 Disabled; Enabling L0S
iwlwifi 0000:09:00.0: L1 Disabled; Enabling L0S
IPv6: ADDRCONF(NETDEV_UP): wlp9s0: link is not ready
r8169 0000:08:00.0 enp8s0: link up
IPv6: ADDRCONF(NETDEV_CHANGE): enp8s0: link becomes ready
usb 1-2: new high-speed USB device number 5 using xhci_hcd
usb 1-2: New USB device found, idVendor=0951, idProduct=1624
usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-2: Product: DataTraveler G2
usb 1-2: Manufacturer: Kingston
usb 1-2: SerialNumber: 001CC0EC34D1F9C126A00CB4
usb 1-2: ep 0x81 - rounding interval to 128 microframes, ep desc says 255 microframes
usb 1-2: ep 0x2 - rounding interval to 128 microframes, ep desc says 255 microframes
usb-storage 1-2:1.0: USB Mass Storage device detected
scsi5 : usb-storage 1-2:1.0
scsi 5:0:0:0: Direct-Access     Kingston DataTraveler G2  1.00 PQ: 0 ANSI: 2
sd 5:0:0:0: Attached scsi generic sg2 type 0
sd 5:0:0:0: [sdb] 31252024 512-byte logical blocks: (16.0 GB/14.9 GiB)
sd 5:0:0:0: [sdb] Write Protect is off
sd 5:0:0:0: [sdb] Incomplete mode parameter data
sd 5:0:0:0: [sdb] Assuming drive cache: write through
sd 5:0:0:0: [sdb] Incomplete mode parameter data
sd 5:0:0:0: [sdb] Assuming drive cache: write through
 sdb: sdb1
sd 5:0:0:0: [sdb] Incomplete mode parameter data
sd 5:0:0:0: [sdb] Assuming drive cache: write through
sd 5:0:0:0: [sdb] Attached SCSI removable disk
armoken
Password:
Last login: Mon Aug  4 21:41:25 FET 2014 on tty1