This is on debian squeeze, with a backports kernel: 2.6.39-bpo.2-amd64 [ 6.103304] [drm] nouveau 0000:01:00.0: PGRAPH: unsupported chipset, please report! [ 6.103660] [drm] nouveau 0000:01:00.0: PGRAPH: unknown config: 2/0/0/0, 1 [ 6.134361] [drm] nouveau 0000:01:00.0: failed to load fuc409d dmesg | egrep '(nouveau|drm|fbcon|fb0:)' [ 5.837562] [drm] Initialized drm 1.1.0 20060810 [ 5.952280] nouveau 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [ 5.952285] nouveau 0000:01:00.0: setting latency timer to 64 [ 5.953207] [drm] nouveau 0000:01:00.0: Detected an NVc0 generation card (0x0c1800a1) [ 5.955917] [drm] nouveau 0000:01:00.0: Attempting to load BIOS image from PRAMIN [ 6.027952] [drm] nouveau 0000:01:00.0: ... appears to be valid [ 6.027959] [drm] nouveau 0000:01:00.0: BIT BIOS found [ 6.027964] [drm] nouveau 0000:01:00.0: Bios version 70.08.19.00 [ 6.027967] [drm] nouveau 0000:01:00.0: Pointer to BIT loadval table invalid [ 6.028045] [drm] nouveau 0000:01:00.0: TMDS table version 2.0 [ 6.028049] [drm] nouveau 0000:01:00.0: Found Display Configuration Block version 4.0 [ 6.028054] [drm] nouveau 0000:01:00.0: Raw DCB entry 0: 08013382 00020030 [ 6.028059] [drm] nouveau 0000:01:00.0: Raw DCB entry 1: 02027362 00020010 [ 6.028062] [drm] nouveau 0000:01:00.0: Raw DCB entry 2: 02013380 00000000 [ 6.028067] [drm] nouveau 0000:01:00.0: DCB connector table: VHER 0x40 5 16 4 [ 6.028072] [drm] nouveau 0000:01:00.0: 0: 0x00000040: type 0x40 idx 0 tag 0xff [ 6.028077] [drm] nouveau 0000:01:00.0: 1: 0x00001161: type 0x61 idx 1 tag 0x07 [ 6.028082] [drm] nouveau 0000:01:00.0: 2: 0x00001231: type 0x31 idx 2 tag 0x07 [ 6.028086] [drm] nouveau 0000:01:00.0: 3: 0x01000330: type 0x30 idx 3 tag 0x5e [ 6.028090] [drm] nouveau 0000:01:00.0: 4: 0x01000446: type 0x46 idx 4 tag 0x5e [ 6.028095] [drm] nouveau 0000:01:00.0: 5: 0x02000546: type 0x46 idx 5 tag 0x5f [ 6.028099] [drm] nouveau 0000:01:00.0: 6: 0x00010631: type 0x31 idx 6 tag 0x51 [ 6.028104] [drm] nouveau 0000:01:00.0: 7: 0x00010761: type 0x61 idx 7 tag 0x51 [ 6.028108] [drm] nouveau 0000:01:00.0: 8: 0x00020846: type 0x46 idx 8 tag 0x52 [ 6.028112] [drm] nouveau 0000:01:00.0: 9: 0x00000900: type 0x00 idx 9 tag 0xff [ 6.028119] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table 0 at offset 0x81E2 [ 6.048234] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table 1 at offset 0x8828 [ 6.055226] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table 2 at offset 0x99BD [ 6.055228] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table 3 at offset 0x99C1 [ 6.055272] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table 4 at offset 0x9AA9 [ 6.055274] [drm] nouveau 0000:01:00.0: Parsing VBIOS init table at offset 0x9B0E [ 6.075098] [drm] nouveau 0000:01:00.0: 0x815C: Condition still not met after 20ms, skipping following opcodes [ 6.093909] [drm] nouveau 0000:01:00.0: 3 available performance level(s) [ 6.093912] [drm] nouveau 0000:01:00.0: 0: memory 135MHz core 270MHz shader 540MHz voltage 860mV [ 6.093915] [drm] nouveau 0000:01:00.0: 1: memory 405MHz core 270MHz shader 810MHz voltage 860mV [ 6.093918] [drm] nouveau 0000:01:00.0: 3: memory 405MHz core 890MHz shader 1120MHz voltage 900mV [ 6.093997] [drm] nouveau 0000:01:00.0: Detected 512MiB VRAM [ 6.103296] [drm] nouveau 0000:01:00.0: 512 MiB GART (aperture) [ 6.103304] [drm] nouveau 0000:01:00.0: PGRAPH: unsupported chipset, please report! [ 6.103660] [drm] nouveau 0000:01:00.0: PGRAPH: unknown config: 2/0/0/0, 1 [ 6.134361] [drm] nouveau 0000:01:00.0: failed to load fuc409d [ 6.151061] [drm] Supports vblank timestamp caching Rev 1 (10.10.2010). [ 6.151063] [drm] No driver support for vblank timestamp query. [ 6.265320] [drm] nouveau 0000:01:00.0: allocated 1280x1024 fb: 0x8020000, bo ffff88011f40d000 [ 6.265378] fbcon: nouveaufb (fb0) is primary device [ 6.321479] fb0: nouveaufb frame buffer device [ 6.321480] drm: registered panic notifier [ 6.321485] [drm] Initialized nouveau 0.0.16 20090420 for 0000:01:00.0 on minor 0 lspci -s 01:00.0 -vvv 01:00.0 VGA compatible controller: nVidia Corporation Device 0df0 (rev a1) (prog-if 00 [VGA controller]) Subsystem: Device 1b0a:9077 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0, Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 16 Region 0: Memory at fa000000 (32-bit, non-prefetchable) [size=16M] Region 1: Memory at d8000000 (64-bit, prefetchable) [size=128M] Region 3: Memory at d6000000 (64-bit, prefetchable) [size=32M] Region 5: I/O ports at dc00 [size=128] Expansion ROM at fbc00000 [disabled] [size=512K] Capabilities: [60] Power Management version 3 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME- Capabilities: [68] MSI: Enable- Count=1/1 Maskable- 64bit+ Address: 0000000000000000 Data: 0000 Capabilities: [78] Express (v1) Endpoint, MSI 00 DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s unlimited, L1 <64us ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset- DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported- RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ MaxPayload 128 bytes, MaxReadReq 512 bytes DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend- LnkCap: Port #0, Speed 2.5GT/s, Width x16, ASPM L0s L1, Latency L0 <256ns, L1 <4us ClockPM+ Surprise- LLActRep- BwNot- LnkCtl: ASPM Disabled; RCB 128 bytes Disabled- Retrain- CommClk+ ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- LnkSta: Speed 2.5GT/s, Width x16, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt- Capabilities: [b4] Vendor Specific Information: Len=14 <?> Capabilities: [100 v1] Virtual Channel Caps: LPEVC=0 RefClk=100ns PATEntryBits=1 Arb: Fixed- WRR32- WRR64- WRR128- Ctrl: ArbSelect=Fixed Status: InProgress- VC0: Caps: PATOffset=00 MaxTimeSlots=1 RejSnoopTrans- Arb: Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256- Ctrl: Enable+ ID=0 ArbSelect=Fixed TC/VC=01 Status: NegoPending- InProgress- Capabilities: [128 v1] Power Budgeting <?> Capabilities: [600 v1] Vendor Specific Information: ID=0001 Rev=1 Len=024 <?> Kernel driver in use: nouveau
Thanks for reporting Support for your chipset has been added in linux 3.0/3.1 Note: 1. linux 3.0 would still require external firmware (fuc****) 2. You would need to append "nouveau.noaccel=0" to your kernel command line to force enable acceleration IIRC there are no plans (from the nouveau team) to backport Fermi support to the 2.6.39 kernel, thus Marking as FIXED
Use of freedesktop.org services, including Bugzilla, is subject to our Code of Conduct. How we collect and use information is described in our Privacy Policy.